3rd Gen 4Runner Interior Hatch Release and Window Switch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handle for opening the hatch on a 3rd gen 4runner from inside. Mount for a factory window switch to roll window down.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 834
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
I followed the information in this forum to add a rear window rolldown switch to the hatch of my 2002 4Runner. I used a factory rear window switch from the front of a 3rd gen 4runner. However, it was too long to fit, so I designed the extension mount to lift it off the hatch. It snaps into place and holds the switch well.
https://www.toyota-4runner.org/3rd-gen-t4rs/191090-3rd-gen-rear-window-cargo-switch-mod-w-pictures.html
Note that 01 and 02 4runners must be wired differently. Read through the whole forum before wiring. Here is a video from PhoRunner that details how to perform the mod on an earlier 3rd gen 4runner:
Additionally, I wanted to be able to open the hatch from the inside of my 4runner. I followed this tutorial:
https://www.toyota-4runner.org/3rd-gen-t4rs/284726-interior-hatch-release-quick-dirty.html
I also designed a handle to make it easier to open. I added a 4mm M3 heat set insert and used a 10mm long M3 hex screw to hold the bike cable to the handle.
I suggest to print these models out of either PETG or ABS. PLA will deform in warmer temperatures.