Prusa XL Print Sheet Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A basic, low-profile print sheet clip to help keep the sheet from lifting when printing large parts.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a very basic clip that slides over the edge of the print sheet and heat bed to keep the magnetic sheet down during large prints.
I ran into an issue when printing large parts for the Prusa enXLosure, specifically the parts that stretched diagonally from corner to corner. As the parts began to cool, the corners of the sheet lifted off the magnetic bed causing them to be dimensionally inaccurate. I tried using small paper clamps/clips but they seemed to interfere with the extruder. Here is my take on the issue.
I used PCCF since I did not have regular PC/ASA/ABS on hand and the clips have held up fine for the past few weeks. Please note - if using CF filament, the edges of the print sheet may become slightly scuffed. The clips will be a bit snug at first.
Print Settings:
0.4 Nozzle
0.2 layer height
2 perimeters
If anybody has any issues, questions, or recommendations, please let me know!