Sunlu S4 extension with 1.6 mm walls
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sunlu S4 Filament Dryer Extension with thin 1.6 mm walls and custom lid. Each extension part is about 300 g of plastic.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 398
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was somewhat repelled by Sunlu own extension for the dryer due to thick walls and no to little optimizations for FDM printing so I decided to implement one myself. I don't like how the lid works in basic version of the dryer so I decided to make it into one piece. However, at least for now, it doesn't have any hinges.
Printing advice:
1. For extension part, place mouse ears with 0 clearance on all corners. Draw them or set angle to 160°.
2. If printing at Bambulab X1 series printer, move it a bit because auto placing would usually touch no-go zone (where filament cutting happens)
3. With 0.3 mm layers and 0.9 mm wide lines with 0.4 mm nozzle it printed in 3h 15m with 316 g of PETG (max flow might be a limitation)
4. Since I only have large PETG spools, I printed extension in PETG and it seems ok when drying at 50°C
5. Built-in support piece can be easily broken off after printing. Some residual pieces might be left though, check to prevent injury later. During printing support provide lateral stability for thin walls.
6. For door central connector make sure that seams are not inside, where original lids would go, otherwise they won't fit.
7. Door skirts are printed 4 times: 2 as-is and 2 mirrored.
8. Door skirts are rather short and required dabs of thermo glue. It's likely can be removed with alcohol.
9. Filament axle is very primitive. I will probably replace it with spool cradle later.
10. For axle to stay in place I made notches in the original dryer body.
11. In order to get spool gliding on the axle you can use a piece of teflon tape.
12. Mine axle was longer than needed and I cut it. Model here is corrected.