Ductless 65mm Whoop Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for my Air65 but it should work with other brands. Weighed the frame at 2.6g which is the same as OEM Air Frame
- Ocena
- 0 / 5
- Polubienia
- 31
- Pobrania
- 167
- Wydruki
- 0
- Wyświetlenia
- 1085
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this for my Air65 but it should work with other brands. I have weighed the frame at 2.6g which is the same as the oem air65 frame.
I recommend printing slowly in PLA with default 0.2mm layer height profile and Arachne wall generation. It requires 2 small Zip Ties to hold the battery and I highly suggest putting them on the frame before the AIO, as it is much more difficult after it is on there.
I started this project just for fun and to see if it would work and after a few failures, it turned out pretty good. This version is not my lightest, but it is the strongest and flies the best. I initially started with a ducted design but that was way too fragile and broke immediately. My other lighter designs either had vibration issues and/or were too fragile.