Dog Leash Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have short (1 foot) leashes on my dogs when they are running free on my patio or in public places where it is…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 25
- Wydruki
- 1
- Wyświetlenia
- 927
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution
I have short (1 foot) leashes on my dogs when they are running free on my patio or in public places where it is allowed. I do this in case I need to get firm control of them in a hurry. The leashes are a little too long to just let them hang as the dogs feet might get tangled. So I created these leash clips for them. They hold the leash safely in a loop but can be released with a tug. They latch together like "pop-beads" and are fastened to the leash in 2 places with small zip ties. They are designed for 3/8 in. / 10mm standard leashes but will probably fit other sizes as well. I expect you could resize them to your needs but be to scale both pieces by the same % to insure a good fit.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: Generic PLA black
Notes:
I was able to print flat w/o supports. Pop them together and twist a few times to smooth the edges and they should work fine. I tried to design them to snap onto the leash but it was too soft to support a good grip. So, I went with zip ties thru the small slot in each clip.
Category: Pets