FormD T1 5080 5090 FE Flipped Travel Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
FormD T1 5080 5090 FE Flipped Travel Kit
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 94
- Wydruki
- 1
- Wyświetlenia
- 2351
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
I believe it’s very important not to block the gap between the motherboard and GPU, since it’s the main source of fresh air for one of the 5090’s fans. I intentionally made it as air-unrestricted as possible. Maybe (unlikely) I will make another STL with some kind of unrestrictive mesh so it looks a bit better.
Travel kit is just two parts: the back bracket and the inner bracket.
Initially, I made a big back bracket that joined with the case using four screws. It looked a bit bulky, so I decided to redesign it to use only two screws and make it much smaller. I was surprised by how sturdy it was, but I wanted to make it even stronger by using longer screws.
That’s how I ended up with four versions of the back bracket:
• Slim – uses two regular countersunk screws that come with the case
• Slim HD – uses 10 mm screws at the joint (my personal favorite, but requires additional screws) – the one used in my final build
• Regular – the one that uses four screws (two countersunk, two flat head)
• Regular HD – for those who want to lift their PC by the GPU on a daily basis or who are using weaker plastic
What about the inner bracket: it’s simple and the same regardless of which back bracket you choose. I added two extra holes to screw in the original GPU screws. It uses 2 countersunk screws to join with GPU and 2 flat head screws at join with PC case
There is a downside in my model: because the GPU is moved as far from the fans as possible (to leave some space for the power cable), it leaves too little room for the HDMI connector. I think most cables will interfere with the case, so I personally cut a bit of the HDMI cable’s housing to make it fit.
• Print only using heat-resistant materials (I used ABS)
• Heat inserts used: M3×4×5 (they work with the screws that come with the case)
• Never tested with a 5080, but it should work
• Please don’t shame me on the white inner bracket—I’m running low on black ABS
Use this kit at your own risk. The author assumes no liability for any damage to your hardware.