Centauri Carbon Vented Riser with Filament Feed Slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the famous vented riser from JesusFreak. Made a slot in the panel to reroute the PTFE filament feed tube.
- Ocena
- 5 / 5
- Polubienia
- 55
- Pobrania
- 591
- Wydruki
- 1
- Wyświetlenia
- 4361
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Reading reviews of the Centauri Carbon, a common early complaint was the routing of the filament PTFE tube through a rather constrictive path. Reviewing various mods, I liked the looks of this riser, but decided to also incorporate the slotted back panel from https://www.printables.com/model/1292227-v2-new-elegoo-centauri-carbon-sliding-riser-with-p .
After printing my modified panel I decided that I wasn't fond of the way the vent control worked. In the original, the off position is in the center, and sliding the that tab either left or right opens the vent. Just felt awkward to me to get the closed position accurately. Therefore I modified the control slider so that CLOSED is all the way right, and OPEN is to the left.
My compliments to JesusFreak for the original design. The Parts assembled easily and the fit is perfect.
Printing Notes:
Filament: PETG (Elegoo Rapid)
Layers: .3mm - This may not be the best choice for quality, but was chosen to reduce the print time when I did the first parts on an Ender 3 V2. Was a bit worried that opening up the vent and control might be difficult, but it worked out OK. At .3mm layers I did have a rough area on the sloped front overhang at the top. The CC printed parts also used .3 layers for a consistent look - but in reality they look much better because the CC works so well.
Supports: Required for the feed tube slot. The slicer will try to add supports in other areas, so add support blockers everywhere except for the horizontal slot.
Update:
Uploaded .3mf file of the slotted rear panel. The file is from Cura which I was using at the time for printing on the Ender 3 V2. This won't be directly usable with Orca, but you can see the added objects used as support blockers.
In all there are 3 support blockers: 1) prevent supports on the vented end of the panel, 2) block supports around the vent control slider, 3) block supports for the top overhangs above the PTFE tube slot. Added some screenshots form Orca to show the support blocker locations I used.