1 / 3
Ethernet Mount for HP T620
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
Description
This Holding part allows for a second Ethernet jack to be mounted within an HP T620 enclosure.
This is needed, if the thin-client is used as a router (Example: pfsense). This plug replaces the Serial or VGA port on the device.
Needed Material
- 1x Ethernet Adapter (https://www.amazon.de/dp/B0788DG7NQ)
- 2x 3,5x10mm self tapping flat-head screw
- 1x “Holder”
- 1x “Retainer”
Printing Instructions
- No Special requirements
Building Instructions
- Remove plug on the RJ45 board and solder the cables directly to it
- Cut the RJ45 PCB to size (be careful not to damage anything)
- Open device housing and remove Serial/VGA plug
- Enlarge hole to fit new plug
- Insert PCB into the holder and mount it into the thin-client with the two screws and the retainer
- Close the housing again
Additional Information
This part was designed with Onshape.
You can also check out my Thingiverse page: https://www.thingiverse.com/a14x/designs