Meshtastic Faketec Vintage "PAGER" WIP CLOSED!!!!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Never seen before design elements in a Meshtastic node combining vintage and advanced functions in one compact node
- Ocena
- 0 / 5
- Polubienia
- 36
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 2848
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPFRONT!
I created a Discord channel for my Thermal vision builds but will add a #meshtastic channel there as well in case you have questions or problems. Please remain to the meshtastic channel for all sort of questions as all the other channels are ONLY for my thermal builds!
_________________________________________________________________________________________________________________________
WIP!! still needs the meshtastic developers to add the new type of screen, as of now the display only works limited in wrong orientation and scrambled!! Worst case this will never happen, so no guarantee given at this point!
you can follow the feature request here on github:
I closed the feature request on Github as I did not get an answer back from the dev I sent the display a few weeks ago. Sorry
_______________________________________________________________________________________________
UPATE 16.07.2025: Firmware test Version from Stary at the Meshtastic discord Forum. :
https://9net.org/~stary/meshtastic_64_128_oled_swapped_width_height.uf2
This makes the display somewhat usable but picture still in wrong orientation and cut at the end. But it is worked on and hopefully there will be a solution soon.
____________________________________________________________________________________________________
My next iteration of Faketec powered nodes.
This is a VERY ADVANCED build and if your not good with thin wires and soldering please dont attempt it!!!!! there is like little room for cables and soldering and placing all the hardware in the case is very delicate!
The faketec Pager uses a faketec V5 revision b. a BME280 ( humidity, temperatur, air pressure) dual GPS, buzzer, vibra motor, rotary encoder for canned messages and menu navigation, easy swappable 18350 battery, foldable antenna and a keychain mounting point.
More info's will be added once the display becomes supported-
______________________________________________________________________________________________________
Part List:
FakeTec DIY Meshtastic Node: preferable V5 or V5 rev. B
gargomoma/fakeTec_pcb: A low-cost nrf52 device.
Rotary encoder:
BME280 Environmental Sensor: 3,3volt
Buzzer: 5x5x2mm
Antenna:
Heltec Federantennen-Zubehör - AliExpress 30
GPS module (GPS +BDS):
TZT 1,3 Zoll OLED Display
Wiring cable 0.3mm:
SMD button kit:
25/140pcs smd taktile Druckknopf-Kit: Werte Dip-Mikrosc halter für DIY-Elektronik - AliExpress 13
18350 Lithium ion battery 1600mAh:
Battery contacts:
Vibration motor:
Magnet: 6x3mm
Brass heat melt inserts: M3(OD4.5mm) Length 6mm
M3 screws: 8mm
the devs.