Right-Angle Housing for Betteri BC01 Connector (Marstek / Duravolt Battery Compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Right-angle housing for Betteri BC01, fits Marstek/Duravolt batteries, print in 2 parts with support, M3x16 screws.
- Ocena
- 4 / 5
- Polubienia
- 3
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 475
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a custom-designed right-angle housing for the Betteri BC01 connector, made to allow closer placement of Marstek Venus or Duravolt home batteries — for example, in tight spaces like flight cases for portable use (small events, mobile setups, etc.).
🛠 Purpose & Background
I made this because I wanted to place a Marstek battery into a flight case and found the original straight connector too bulky for that. To avoid voiding the warranty, I didn't modify the original connector. Instead, I used a new BC01 connector and designed a custom right-angle housing around it.
This housing is not waterproof. Use it at your own risk — I take no responsibility for any consequences.
🔩 Hardware Needed
2x M3 x 16mm screws
A new Betteri BC01 connector (I kept the original intact to preserve warranty)
Cable strain relief is designed for 3G2.5 mm² cable
🖨 Print Settings
Material: PLA/PETG recommended
Orientation:
Housing: Print standing up
Cover: Print flat
Supports: Yes, both parts need support
Infill: 30–50% (for strength)
Layer height: 0.2 mm
🧩 Notes
The design includes strain relief to reduce stress on the cable.
Cable routing comes out at a 90° angle, making it more compact.
Designed specifically with Marstek battery connector clearance in mind.
This is not a sealed or IP-rated enclosure, only intended for indoor or dry protected use.