Low-profile topbar for Corsair Dominator RAM
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A low-profile topbar for Corsair Dominator RAM sticks. Compatible with the RGB-module from the original ones.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Some simple topbars for the Corsair Dominator RAM sticks. I designed them a while ago as a low-profile alternative because the original ones were a bit too tall and collided with the radiator in the top of my PC case. The body is quite thick and slides partly over the top of the RAM sticks, so they might not fit if you have all four RAM slots filled.
Caution
These topbars are not as high as the original ones. You will need shorter screws to mount them, otherwise you might damage your RAM when trying to mount them.
The screws that came with the original topbar seem to be M1.6 x 16mm but I have no confirmation from Corsair that these dimensions are correct. The screws used in the example pictures are M1.6 x 5mm. Measure the dimensions yourself before trying to mount the topbar.
If you are planning to use the RGB-module from the original topbar: You will have to remove it from the original topbars. I don't know if this might void your warranty.
Use at your own risk.
Printing
The topbars consist of two pieces: an outer body and a lightbar. If you want to use the RGB-module that came with the original topbars you may want to use a translucent instead of a clear filament for the lightbar to get a more even light distribution. The filaments used for the topbars in the example pictures are Fiberlogy Matte Grey PET-G for the body and Geeetech White PET-G for the lightbar.
I printed both parts on a Prusa MK4 with a layer height of 0.10mm and a 0.4mm nozzle.
Mounting
- Insert the lightbar into the outer body. Both parts are a quite tight fit.
- (optional) Install the RGB module with the same screws with which they were mounted in the original topbar.
- Slide the topbar over the RAM stick and secure with the two screws.
Known Issues
The material at the contact surface between the screw and the body is quite thin and might break if you mount the screws too tightly. I made this decision because I wanted to keep the topbar as low profile as possible and still wanted the screw heads to be flush with the top surface. And I really needed that space (see the last picture for reference). I might change this design in the future, if you want a slightly higher version of the topbar and I find the time to do so :)