Clipper&Beer Car Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The ultimate holder kit for the party car
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 41
- Wydruki
- 1
- Wyświetlenia
- 534
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The smart device that can hold your drink and keep always handy your favourite clipper lighter. It is recommended to just drink and do not drive, petrol pricing also suggest to not drive even sober.
Fitting is intended to be sliding fit and may experiment some air suction braking. A bottom hole in the clipper holder was added to be able to fill the lighter and help release it in case is required.
Designed to fit regular drinking cans 33cl, 44cl, 50cl (66mm diam.) including imperial size (2.6in).
Clipperholder has the right size to fit regular and short standard clippers.
Enjoy
INSTALLATION
Regular counter-sunk screw T82-M3.9 (DIN 7982). Check screw table photos. Clipper hole is intended for clipper gas charging or release, but can be used to fix rotation using a pin or a small screw:
- Minimum length 9.5mm. 13mm recommended.
- Can fit other screws as T81, T83 etc. See catalog attached.
- Can fit M4.2 or M3.5 sizes if required.
- Tightening over PLA, tight with care.
---------------------------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------------------------