QRZ Explorer-1 desktop base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Non-Charging base for the QRZ Explorer-1 HT
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I got tired of my QRZ Explorer-1 HT falling over when I had it on the desk with a longer antenna on it. I also only had a single charging base and I wanted to be able to charge batteries and work separately. This is a straightforward design that holds the radio at a 10 degree angle so it is easier to see. The tolerances are purposely loose, but they hold the radio securely.
I put a small generic rubber foot, about 1/8" thick on the back side for the radio to rest against. This provides just enough friction, though it is not needed.
I printed this with 20% infill in Sunlu PLA+