1 / 1
A spherical lamp for 12 5mm LEDs and 6AA batteries. — zdjęcie 1

A spherical lamp for 12 5mm LEDs and 6AA batteries.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A spherical lamp for 12 5mm LEDs and 6AA batteries.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
43
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a battery-operated spherical lamp in which 12 5mm LEDs can be installed in any colour.

All printable parts are required for the lamp. The parts that form the sphere must be printed with transparent filament. To achieve good quality, the two half-shells should not be printed too quickly.

You will also need

  • M3 screws (I helped myself from my leftover box, just check that they are no to long or to short)
  • M3 nuts
  • Switching power supply (I soldered one myself, a ready-bought one also works)
  • 12 x 5mm LEDs
  • 12 x series resistors that match the selected LEDs and the voltage of the power supply.
  • 6AA battery block
  • Slide switch Dimensions 12mm x 7mm
  • Cable

Assembly instructions

1.) Glue the LED holder LED_sphere-2 into the lower half shell LED-sphere_1.

2.) Insert an M3 nut into LED_sphere-4 and glue the LED_sphere-4 into LED_sphere-3 with the nut facing downwards.

3.) Insert all other M3 nuts.

4.) Solder all cables that supply the LEDs with power.

5.) Insert the LEDs in LED-sphere_1 and LED-sphere_3.

6.) Pull the cables through the four holes in LED-sphere_1 into the socket.

7.) Screw the two half shells together with a sufficiently long M3 screw, which is fed through the opening in the centre of the lower half shell.

8.) Connect the cables of the LEDs to the power supply unit. Then screw the LED_sphere-5 base onto the lower half-shell.

9.) Glue the switch to the base plate of the LED_sphere-6 base.

10.) Place the 6AA battery block in the LED_sphere-6 base. It should be firmly clamped in the base.

Screw the base to the LED_sphere-5 base.

 

Tagi