Digimon Pendulum COLOR Case - Easier to print and improved durability

This is an edit of the wonderful Digimon Pendulum COLOR Case uploaded by jyoshi1909 on Thingiverse, which itself is based on the vintage iremon cases. This version has been edited to make it easier to print on FDM printers and to improve durability.

The original version is difficult to print on FDM printers due to the overhangs, this would leave a rough area which required sanding, and the latch was very brittle and would break easily when opening the case (Which you might do often to connect with other devices or to swap the device in the case with another from your collection). To fix this, I expanded the flat section at the top and bottom of the case by 8mm on the left and right sides which made the slopes on the edges of the base able to print without issue, so now there is no need for sanding or anything after you print. Just remove the supports and you're ready to go. As for the latch, I replaced it with the latch mechanism from the standard Digital Monster case which was also posted by jyoshi1909. This latch is much more durable than the one from the Pendulum case. The buttons are the same as the ones that jyoshi1909 posted and I did not modify them in any way, but I am including the file here for convenience. Separate the buttons into groups of 3 but keep each group connected by a strip, it makes it a lot easier to deal with when you take your Pendulum out of the case.

I printed mine on an Elegoo Centauri Carbon printer. Here are my recommended print settings:
0.12mm layer height
25% infill
Use tree supports
I printed mine on a smooth cool plate meant for PLA (Side B on the stock Centauri Carbon PEI plate) with a bed temperature of 35 degrees Celsius.
Apart from that I left everything on default settings.
Orient the case body right side up on the build plate, and orient the lid upside down. Auto orientation will probably pick this orientation by default.

I also tested with 0.2 layer height, it looks fine and seems strong, but I prefer 0.12 as it looks much better and it doesn't take long to print  (Around an hour and a half to print the whole case on 0.12 layer height).

If you are going to sell these cases you must follow the rules that jyoshi1909 posted on his profile, and you must also notify me and receive my permission.