xbox meta quest 3 controller and ear bud box mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
these are accessories for the Kiwi meta quest 3/3s charging rgb stand.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 430
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
uses the 38924-xbox-controller-stand as a basis for this add-on to my Kiwi Meta Quest 3s RGB vertical stand which I added some custom pieces so that it would attach to it.
the earbud mount is custom designed by me for my Prismxr Vega T1 from amazon also.
I found the logo version has ghosting which would be gone totally if resin printed and to be honest even after reprinting ( I am using the non logo variant) it still looked naff due to ghosting.
the logo inserts can either pushed in or glued.
I would print the logo insert using a small nozzle size <0.4 as the upper part of the X doesn't go to the sides when pushed in (or you could just paint the X instead).
the controller holder just fits by by mounting it higher then lowering it down until its resting at the bottom (it will push into place but may scratch your kiwi rgb headset mount).
the earbud holder just pushes into place of one of the rear square holes (use the middle lower two holes as the usb c cable may get in the way.