Vasemode Modular Drawers V2

FreeCAD source files included.

Updated design of my modular drawers, I gave them a diagonal tilt so that they will not fall apart nearly as easily as the first design, individual cells slide onto each other with a stop on the end of each so they will not slide past.

INSTRUCTIONS

Recommended wall thickness for vasemode: 0.6-0.7 mm

First you need the “base” part, that goes on the bottom of each column and should be printed normally, this part takes the longest to print but you only need 1 per column.

Second, print the “cell” parts in vasemode, once printed they should slide with a little resistance onto the base, and with little resistance onto another cell, they can be stacked at least 12 high without issues.

Then, print the “drawer” parts in vasemode, once printed they should easily slide into the cells, they can be pulled out with the cutout on the bottom. They can be labeled with 20 x 28 mm stickers.

Expand, make as many as you need, lots can be make with a single spool of filament.