eSUN vacuumpump mount for CORE One
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a small holder to place an eSUN eVacuum Pro 3 on the back of your Prusa CORE One
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought an eSUN eVacuum Kit Pro 3 recently to better store my filament. I designed a simple holder to store it on the back on my CORE One. There are two empty screw holes on the left side of the fans that can be used to attach it to the printer. If you have a filter attached those screwholes are most likely in use. I don't have the filter.
The hole for the vacuum pomp seems too big, but it has a rubber flange that needs space. The hole for the sealing clips have a slight wedge on then so they (hopefully) won't rattle when the printer is moving.
Needed materials:
- 2x 3m6 screws
Printing instructions:
Be sure to rotate the model so the bottom (the side with the single small hole in it) is down - the large hole should be on top. I used Prusament PETG at 0.20mm SPEED. But it should also work with PLA.