Picture Frame for my HueForges
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Picture Frame for my HueForges Multiple sizes Multiple thickness
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 153
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial
A frame that is generated to clamp the hueforge image directly into the frame with an overlap of 2mm at the front and 5mm at the back with the option of attaching an additional piece to mount to the wall on or a foot to stand on a table.
Used model in example is here: https://www.printables.com/model/1352472-sauron-picture-hueforge
1. Determine the size of the printed image - e.g. 170x170 mm.
2. Always measure the thickest part at the edge of the hueforge of the printed image - e.g. 2.1 mm.
3. Find the corresponding file with the size and thickness of the printed frame - e.g. 170x170x2.1mm
4. Always print the frame with the ‘hanging bite’ facing upwards - turn upside down in the slicer if necessary.
4. a) Rotate 90° in Z-Axis
5. Find the layer where there is a 5mm overlap. The slicer usually marks the overlap with a special colour. Place the pause here - e.g. layer 21.
6. Proceed to printing. While pausing the print, place the image in the slot, then resume. The next layer will be printed on the back of the already printed image. If the 1st layer does not snap prefectly, stay still and let everything finish printing.
You can see the results for prints on my profile for images labeled HueForge.
Picture Stand/Holder: https://www.printables.com/model/1355017-picture-frame-holderstand-for-my-hueforges