Prusa Core One Webcam Mount for Logitech C910 (for 6x1mm magnets)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick and dirty remix to add support for the Logitech C910.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 32
- Wydruki
- 2
- Wyświetlenia
- 368
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a few small tweaks to Blue's design to the support the Logitech C910. I'm using an M3-35 screw and M3 Nyloc nut.
You need to remove the mounting base but the pathway is set. The tolerances are tight so pre-thread the screw through once before installing it on the camera. I had 6x1mm magnets so the magnet pockets are shallower on this model. Note that the screw cap and nut sink fairly deep into the capture.
The ferrite choke on the cable will not fit on the standard buddy-cam pathway so I ran it up and over, with a single small zip tie in the top back corner to hold the cable out of the way. I routed down and then through the left pass through and finally down and out the cabling channel into an RPi on the back of the CORE One.