Organizer For Infinitokens Game On Bundle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An organizer for the Infinitokens Game On Bundle. Stores Markers, Eraser, Cards, and Counters.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial
What This Is For
I wanted a compact way to store my Infinitokens pieces so I could easily have them handy when playing games.
Prints as 3 pieces. Hinge is assembled with a 1mm brass rod. I printed in PLA using the .25 Structural Preset on a MK4S. No supports needed.
Bill of Materials
Besides the 3 printed parts you will need
1x Infinitokens GAME ON Bundle
2x ~39mm Segments of 1mm Rod, I used Brass Rod
(Optional) Soldering Iron or similar to melt rod into hinge
Printing
Parts should be oriented for print, no supports needed. You will need to set pause points during “Tokens and Cards Organizer" and “Marker Clip Organizer” to insert the magnets. You should need 2 pause points. When inserting the magnets, carefully check the orientation will be correct to have the magnets attract each other.
1x Tokens and Cards Organizer
1x Marker Clip Organizer
1x Token Containment Slider
(Pictured parts were printed on a textured sheet)
Assembly
- Combine Token and Cards Organizer with Marker Clip Organizer
- Insert 1mm Rods to connect hinges
- (Optional) Slightly melt the holes where the hinge rod was inserted to make it so the rod cannot fall out.
- Clip in markers. Insert cards and tokens. Token containment slider slides to cover the token.
- Eraser sits on top of the card stack.
Customizing
You can customize the design, it is available in Onshape. Infinitokens Organizer In OnShape.