1 / 10
Magnetic dust collector fittings, threaded for 2.5" hose — zdjęcie 1
1 / 10

Magnetic dust collector fittings, threaded for 2.5" hose

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Male and female magnetic connector for dust collection hose, threaded

Ocena
0 / 5
Polubienia
15
Pobrania
117
Wydruki
1
Wyświetlenia
472
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

There are a number of dust collection fittings that are magnetically connected for ease of moving the hose from one machine to another.  However, many of these are for 4" diameter hoses, and require clamps so that the fitting will stay on the hose.  They are also often fairly expensive.  

This design is threaded on one end so that it simply threads into the 2.5" diameter hose.  The magnets are flush with recesses on one piece and washers or other steel discs are simply glued into the other side to make the connection.   There is also a lip around the outside edge for alignment purposes.  So, the two pieces are lined up and then rotated a few degrees to make the connection.  

This design will fit this hose:  https://www.amazon.com/dp/B0CY2WZPJK?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

But, it's likely that other 2.5" diameter hose would also work.

In addition,  here's another version with a different hose: 

https://www.printables.com/model/414801-magnetic-coupling-for-50mm-hose

This design was done in Onshape.  It can be found here:  

https://cad.onshape.com/documents/98f79b4fbda5bb1f88fa47cb/w/847419c58165b1b94d07ad1b/e/e7e13b7a07319fb01349c75e?renderMode=0&uiState=687531d98b7ec81fcfc563b1

Note that you will probably want to add supports for the threads, depending on your printer.  I used the automatic organic supports in Prusaslicer with my MK3.9S+, but many other choices would also work.

Tagi