Gridfinity case for "Mini temp tower"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Eight Mini temp towers can be stored in this gridfinity 1.5x2x5 case as filament swatches.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Share Alike
"Mini temp tower" by Tommy Zero is excellent. We can test a filament with short time and little materials.
I wanted to store the printed towers as filament swatches.
This model can store eight mini temp towers, and it is gridfinity compatible (fractional 1.5x2), refined with the snap-in magnet slots (ϕ6mm x 2mm) and thumb screw holes.
Fractional Gridfinity
https://www.printables.com/model/616289-fractional-gridfinity
Gridfinity refined
https://www.printables.com/model/413761-gridfinity-refined
When stored, the top of the temp towers is at 5 unit (35mm) high and the case have partial gridfinity lips on both ends. So, the case becomes pseudo gridfinity 1.5x2x5 unit, allowing another Mini temp tower case stacked on it.
The side walls of the case have openings at the bottom to have the ability of storing warped towers.
Printing
- No support is needed.
- With PLA, the bridges in the side wall may pull and deform the other two taller walls, making the two slots at both ends too tight for full height temp towers. Choose the printer setting carefully or use PETG to avoid it. Or, you can just use those deformed slots to store partial height temp towers.
Happy printing!