1 / 1
Cutting Jig For Plunger Tubes For Homemade Nerf Blasters — zdjęcie 1

Cutting Jig For Plunger Tubes For Homemade Nerf Blasters

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Easily cut your acrylic tubes to length. Includes integrated measuring device (metric and imperial)!

Ocena
0 / 5
Polubienia
13
Pobrania
36
Wydruki
0
Wyświetlenia
174
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This cutting jig is for everybody wanting to (somewhat) precisely cut their own plunger tubes without having access to a miter saw or similar.

Takes tubes up to about 50cm / 2" in diameter.

Just slide the stopper to the desired position, lock it into place with two screws on the underside and start cutting.

The minimum measurable distance is 25.4mm / 1", any shorter and you'd need to mark your cut by hand…

…or think about why you'd want to cut a less than one inch long plunger tube.

 

Requires a sawblade no thicker than 1mm; a cheap japanese trimming saw works well.

 

Requires two cylindrical M5x10 bolts and matching nuts for the locking function.

 

Assembly should be pretty obvious, it's two parts…

…although threading the nuts onto the bolts may be a little fiddly.

 

Please note: the measuring marks are more a suggestion than a precise distance, always measure / mark the length yourself.

Also note: the cutting function has been extensively tested, the measuring function not so much. Use at your own risk.

 

One last word of advice: as this will definitely get damaged while using (probably being cut into), use your cheapest / most expendable filament

Tagi