The LaSt NERVE!

The LaSt NERVE! is a game that gets YOU on your last nerve. It’s a puzzle game like Tetris — but trickier. There’s a cheat sheet for Exit Enthusiasts (spoiler: it’s not very good), so Exit Enthusiasts, WATCH OUT!

Want a shortcut? Just summon the Hammer of Ultimate Chaos and give it a good whack — instant fix, or now you’ve got a confetti explosion of broken dreams. Either way, you win… or do you?

• Remember: It MUST all fit in the box when done. No extra edges sticking out!!!
• PRINT SETTINGS
• 15%–20% infill
• Brim or Raft will work (or none)
• FAST mode on Cura slicer is fine
• Supports: Only touching build plate (normal)
• PLA filament works perfectly
• Print bed heat: 60°C
• Nozzle heat: 200–210°C
• (Just match nozzle and bed temps to what’s listed on your filament roll)

Only took my ELEGOO Neptune 4 Plus 39 minutes to print on normal settings — not bad for something that might destroy your sanity!

it also comes with a case with a nice lid to fit your whole design in {}{}{WARNING!}{}{}

{fits in its case almost TOO good}