1 / 1
Hero Me Gen5 CR10-V2 Gantry Adapter - better air flow+alignment+fit — zdjęcie 1

Hero Me Gen5 CR10-V2 Gantry Adapter - better air flow+alignment+fit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I noticed a reduction in cooling of the V6 clone heatsink on the CR10-V2 compared to the stock cooling. So I added…

Ocena
0 / 5
Polubienia
3
Pobrania
28
Wydruki
0
Wyświetlenia
488
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I noticed a reduction in cooling of the V6 clone heatsink on the CR10-V2 compared to the stock cooling.

So I added some vents into the adapter plate to allow the air to escape, makes a slight improvement.

I also added ~3.02mm to the the thickness to bring the nozzle back into the same alignment as the original this allows you to use standard direct drive brackets designed for the CR10-V2 without the need for redesign of the direct drive mount.

The final change is I added captive nuts for mounting to the back plate so it makes it MUCH easier to fit this way round with bolts going in from the back like the stock enclosure.

Added bonus the original BLTouch mount on the right hand side fits behind front mounted 4020s.

I used the original as a template and knocked it up in Fusion 360, probably can be improve but its better than the stock part for me at least.

Added the Fusion 360 f3d files if you want to modify yourself.

I added the vests against the backplate as I assumed that is where the most pressure would be but may be better at the front of the adapter

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

45%

Filament: Basicfil PET Black


Notes:

I made this with 4 top & bottom and 4 walls with 45% infill so nice and solid.
This PET is super stringy at 240C and due to the rising heat I had to run around 40mm/s to stop it jamming as it goes soft in the tube from direct drive to hot end.

Category: 3D Printer Parts

Tagi