CGS/MWS NPAS and nozzle accesories
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spare parts for CGS/MWS GBBR airsoft replicas
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 120
- Wydruki
- 0
- Wyświetlenia
- 927
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
22.08.2025 - Added shorter nozzle attachment spring parts (-1 and -2mm) which will allow to adjust the Joules output beyond stock limit, but be careful with gas efficiency/cooldown. Also, a tapered nut to be used with hammer assist.
NPAS/adjustable rocket valve, nozzle return spring attachment from both sides and small quality of live improvement for CGS nozzle replacement. You will need M3/M6 taps. M6 threads are modeled, but at least in my case, screwing in directly didn't work - it was too tight.
When tapping the NPAS, I recommend to not tap the full lenght - remaining unthreaded plastic helps a lot with securing the screw from vibration etc.
For the spring attachment, you will need a headless M6 screw with a flat tip. I recommend using a hex-head screw as it is easier to fix it compared to the flat head screwdriver. M6x20mm should be OK.
I recommend to print slowly, at high temperature, low layer height and using some kind of CF material for best layer adhesion. Acetone smoothing or a superglue layer can make the surface smoother, can be useful for the valve as it a moving element.
Holes for spring attachment pins are nominal 2mm, most likely you will need to drill to make the hole nice and round.
If you need any support, let me know!