1 / 8
Denon DP-35F power cord clamp
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A drop in clamp for a replacement 18 AWG power cable. Slots into the original power cord location.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to replace the power cable on my Denon DP-35F turntable. The old cable ended up being a little smaller than the replacement. So I designed a new cable clamp to prevent the power cable from being pulled out and damaging the transformer.
I designed the part to fit in the original location on the turntable. So it's a drop in repair only needing very simple parts.
- x2 12mm M3 self tapping screws for plastic
- Superglue
To assemble;
- Take 2 clamp halves and pre tap the threads for the screws. The ensures it goes together smoothly.
- Pull it apart the clamp and insert the power cord. The fit should be snug, this is on purple to add friction. Once you have the right amount of cable pulled through (1 to 2 inches was enough for me) place the clamp around the cord on the back of the faceplate.
- Thread the screws in and tighten down, just be sure not to tighten so much you strip the screws out.
- Superglue the LEFT HALF ONLY to the faceplate. Doing so will allow you to replace the cable again or remove it if needed.
- Drop the part into the turntable slot and button up the bottom plate.
Enjoy!