3 Pen Stand/Penholder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
N.B. Pens shown for demonstration Only
I made this pen stand for my desk, to accommodate clips too as I like to have them nib-down whilst in use. It was inspired by my razor stand of similar design.
I printed it in PLA, I've no doubt it would print well in other materials too. I found it prints fine on its side with no support, or upright with minimal organic supports. It's worth experimenting.
Dimensions (Approx.) as follows:
- Width: 68mm x Height: 49mm x Depth: 44mm
- Hole Diameter: 15.5 mm
- Clip width: 8mm
I hope this helps. Please leave a like if it does, and post any makes or remixes.
All designs (however rubbish) are my own, unless they're an accredited remix of another great design. They are made available for non-commercial use. Sale of design or prints is prohibited. You may find some of my other models interesting and/or useful too, please take a look.