Bicyle Tire Lifter/Lever Stackable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
When changing a tire you need multiple of these lifters That´s why you need this tool that you can print in one go!
- Ocena
- 4,25 / 5
- Polubienia
- 40
- Pobrania
- 408
- Wydruki
- 4
- Wyświetlenia
- 1277
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
The jack is there to replace the bicyle tube of your tire. When changing you need more than one of them (Best are 3 ;-)) That´s why there are 3 versions the single, double and triple version.
They snap together when not in use. You don´t need any support material in this print!
With my Prusa MK3S+ it prints perfect. The clearances are designed in a way that this is possible. When finished you need a little force on the side shown in the last picture.
If you have any issues or ideas how to change them please let me know I am happy to adapt them!
CHANGELOG:
v. 1.0 - Original version.
Print instructions
The setup was created for PrusaSlicer 2.4.0
Key Print Settings
- 0.1 mm layer
- Generic PLA
- Setup for MK3S+
- Fill density 15%
- Support material is turned off you don´t need it here
Sliced Info (for the setup above and the triple):
- Used filament: 6.4m / 19.08g
- Estimated printing time (normal/stealth): 4h02min / 4h05min