1 / 9
WySaPi - Wyoming Satellite Pi for Home Assistant Voice
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for a Raspberry Pi Zero 2 WH with 2-Mic Hat and a 3W speaker, to be used as a Wyoming Satellite for Home Assistant
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 471
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (24)Powiązane
I recently migrated to Home Assistant, and after discovering the Voice Assistant possibilities, i designed this case to nicely package a Raspberry Pi Zero 2 W with a Keyestudios ReSpeaker 2-mic Hat and a 3W speaker.
The idea behind the offset lid is to be able to wrap the lid in thick mesh fabric to make it look nicer, while still allowing for sound to make it to the microphones and of course out from the speaker.
Bill of Materials:
- Raspberry Pi Zero 2 W - get one with the pins already soldered on, preferably
- keyestudio ReSpeaker 2-mic Hat (any similar hat should work, too)
- 3W Mini Speaker
- USB-C Socket for panel mounting
- Micro-USB Power Connector PCB
- Mesh Fabric
- a little bit of wire to connect the USB-C socket with the Micro-USB PCB
- JST-PH 2.54 plug for the speaker
- optional: some rubber feet
To mount all the parts, you will also need:
- 3x M3x20 socket head cap screws (for the case and lid)
- 2x M2x6 or M2x8 screws to mount the speaker
- 4x M2.5x5 screws to mount the Pi stack
- 4x M2.5x11 standoffs between the Pi and the ReSpeaker hat
- 4x M2.5x5 standoffs below the Pi
- 3x M3x4x5 heat-set threaded inserts ("Voron-style")
Notes:
- Even though the Case & Lid models are not likely to change anymore, this is still missing a diffusor / button part to enable muting the microphone (press to toggle) and shutting down the Pi (hold for e.g. >5s to shut down) - but the Case & Lid should not change anymore.
- I'll also try with a second layer of fabric to hide the internals a bit more.
- And lastly a template for cutting the mesh fabric.