1 / 1
UNW airsoft GBB version of: Unseenkiller spagetti 17 PY2A — zdjęcie 1

UNW airsoft GBB version of: Unseenkiller spagetti 17 PY2A

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

should be as simple as dropping in the parts

Ocena
0 / 5
Polubienia
10
Pobrania
82
Wydruki
0
Wyświetlenia
377
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

12-10-2025
models are updated so that the slide lock cant be pushed outwards. what causes extra slide ware
this can be fixed with a 0.6mm spacer if you want to update a printed frame
-

29-07-2025

I have moved the mag 0.5mm up. this should be better. but this not tested with other users.

------

21-07-2025 update
I had to update the Gen 4 model so the mag release button cant fall out this was a thing that could happen based on how the original model was designed that I over looked

__

extra note on this model: I needed to make the pin hole for the front rail a bit smaller to avoid a modeling error. so I made it the correct size for so far I could. and there should be only like 1mm or 2mm that is to tight on each side.

--

just a cosmetic chance to the lower in this case styled after a design made by UNSEENKILLER

compatibility note: 
WE-tech G series 17 and 18 from gen 3 up to gen 4 (5 will be added later)
TM G series 17 gen3: fits
AW VX7 and VX8 : should fit the Gen 3 version but this is not tested
G-force 17 : should fit the Gen 4 version but this is not tested
Nuprol: Raven / Vorsk EU7, EU8 is most likely compatible and should be used with the gen4 version

assembly note:
you might want to look up some videos in case your new to disabling this model of GBB. but it should be same as dissembling and assembling a official one

Tagi