Single Folded Ascender Extruder (Worm Gear Extruder)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
15:1 1M worm gear extruder. Remix of annex engineering double folded ascender.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
https://github.com/Annex-Engineering/ANNEX-Engineering-License-Agreement
Please follow the license agreement above.
Mostly putting it here for my reference/people to see. Used my spare parts so it's not easy to build your own. You probably need to mod this to use different bearing/roller. Does use standard bmg gear.
- 2 od 8mm and 1 od 9mm bearings for the main shaft
- 1mm spacer for the main shaft
- 13mm roller from titan extrder
Overall cost is around $20 from aliexpress.
- bmg - $4
- worm gear set - $12
- shaft - $5
- also need additional bearings etc
When assembling, move the stepper up and down so that there is a tiny bit of slack (as little as possible). When fully pressed, mine started binding. Not sure if it's gear quality or not. Also apply lots of lube. Put a wash between stepper and mount on one side to fine tune as needed.