snapon nozzle wiper for flashforge AD5M

Nozzle wiper for Flashforge AD5M that can be snapped on to the build plate. 
It uses the bambu lab A1 silicone wiper.

It is compatible with the Flashforge Adventurer 5M Pro defaults, that is
- works with default bed leveling routine
- works with default purge line

Printbed model

I included a model file for the print bed with the attachment. You can change this for orca slicer in the printer settings→Printable area: Set→Model→Load…

it should look like this:
 

!!! Flashforge 5M Pro center is probably not as shown !!!

The center is probably not nicely in the middle of the bed as in the preview. At least for me it wasn't. For my printer everything was shifted to the upper right corner, which is the corner for X and Y homing.
My deviation to the center was 1.8mm in X-direction and 3.6mm in Y-direction. 

Btw its also skewed a lot. The FF printers can be very dimensional inaccurate. My printer has almost 0.8% length difference across the x-axis.

Exclusion Area

You can also specify an excluded area to prevent the print head crashing into the attachment.
Sadly orca slicer is buggy and you cannot set this via the GUI.
There is a github issue where i explain the details.
If you are in a better future and it is fixed (negative values allowed) you can put this under “Exclude bed area”: -96.5x-95,-96.5x-110,-52.5x-110,-52.5x-95
I haven't tried PrusaSlicer.

So far you need to change the settings file directly. For linux the path is something like
~/.config/OrcaSlicer/user/default/machine/Flashforge Adventurer 5M Pro 0.4 Nozzle - myProfile.json

In the file add the following:

"bed_exclude_area": [
"-96.5x-95",
"-96.5x-110",
"-52.5x-110",
"-52.5x-95"
],

Those coordinates correspond to the read area in the following picture:

Wiping procedure

Work in Progress…