1 / 2
Pi HQ Camera Mount for the Articulating Camera Mount v2
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed the original model by @br4in to include inserts for M2.5mm nuts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Remixed the original model by @br4in to include inserts for M2.5mm nuts and increased the overall size slightly to accommodate the nut inserts.
This version allows for the original model screws to be used as intended, with M3x5 screws should you choose, or with M2.5x5 screws and nuts.
Link to the hardware I have on Amazon, HERE.
Print Settings
- Layer height: 0.2mm
- Supports: None, but supports help the bridge for the ribbon cable to print clean
- Infill 10%
- Prototypes were printed in PLA; final print was done in Prusament PETG.
Assembly Options
- Option 1 - No screws. The mount fits firmly to the screws on the back of the PCB board, but may fall off with prolonged vibration.
- Option 2 - 2 or 4 M3x5 screws. The screws will carve their threads into the PCB board and the plastic of the mount. Be sure to thread the screws straight so as not to cross-thread.
- Option 3 - 4 M2.5x6 Screws, and 4 to 8 M2.5 nuts. This option is the preferred method for this remixed model. This provides a firm fit and allows for resuability.
- Insert nuts into the holes in the back of the mount.
- Attach the mount to the back of the PCB board, as the two holes will hold it in place.
- Optionally, you can use 4 M2.5 nuts between the PCB and the mount for stability
- Insert 4 M2.5x6 Screws into the 4 holes at the corners of the PCB.
Please share your makes and comments for improvements.