Replacement HP/Agilent/Keysight foot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Generic replacement foot for most HP/Agilent/Keysight instruments that use the normal clip-on feet.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 92
- Wydruki
- 1
- Wyświetlenia
- 197
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
Generic replacement foot for most HP/Agilent/Keysight instruments that use the normal clip-on feet, with or without the flip-down wire.
There are separate front and rear feet (some instruments were shipped with distinct ones; others seem to have always come with just the front-type). Either fits either end of the instrument; the rear feet have non-slip rubber inserts originally, whereas front feet have a lip to align with the instrument below in a stack. These feet match height with the originals; you can print a block to insert in place of the original rubber pad for the rear ones, or you can just print it in hard plastic (or even recycle a real block off an original foot, they're designed to be compatible).
I strongly recommend printing the “hooks” at 100% infill. They can snap off inside if you try and release them and they're not strong enough! I use a height range modifier to do this in PrusaSlicer.