Large Clean/Dirty Dishwasher Sign
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Indicates if your dishwasher is clean or dirty
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 194
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My Clean/Dirty Dishwasher sign is relatively large compared to other signs, its 162*48*12mm. This makes it easy to read from a distance or across a room.
Text Plate options
There are two versions of the text plates, one is a single text plate with both clean/dirty written on them and there is two text plates split into clean and dirty so you can change the foreground colour for the text. Please use the separated clean and dirty text if you're planning on doing that.
My print settings
- Printer: Mk4st
- Filament used: Prasment PLA Gentleman's grey, Prusament PLA pearl white
- Layer Height: 0.2mm
- Layer Thickness(nozzle): 0.4mm
- Print Time: 1h 45m
Keep in mind changing the layer height may affect the magnets ability to fit. In my testing the Main Body has not needed supports for the overhangs where the magnet hole goes under the wall.
Top Fit clearance (IMPORTANT)
If you're not sure about the minimum clearance of your printer please use the 0.1mm top fit, this should work just fine on nearly any printer though you will probably need to glue the part down. Otherwise the 0.02mm fit should offer a fit with no glue required, though please keep in mind material shrinkage may change this and not make it work properly.
Magnets
The sign uses two 20*6*2 magnets that slot in on either side, when inserting them the polarity does not matter. If you have the MMU upgrade for the prusa enclosure you should already have these magnets lying around. Otherwise, they are available on Prusa's website!