true1 PDU conversion daisychainable / Umbau Steckdosenleiste auf true1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Conversion of Logilink PDU9C02 and similar for true1 in and out
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 330
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to have some affordable daisychainable true1 PDUs so I designed two new ends fitting a reasonably priced logilink PDU9C02 and Rean true1 sockets/outlets.
Print one of each PDU in and PDU out
Best printed in PETG
Place on the outfacing side, add some support for the later invisible area underneath the sockets
The Rean inlet/outlet can be fixed with 2 M3 Screws each (approx. 10-12mm countersunk)
Wiring at your own risk. There is room to route through an additional cable to power the outlet side. I suggest wiring it directly to the input, so the output is not disabled when the switch is turned off.
When dasychaining keep in mind you must not draw more than 16 amps from one chain in total.
My sourcing of the parts:
Rean RRAC3M-X-000-1 https://www.thomann.de/de/rean_rrac3m_x_000_1.htm
Rean RRAC3F-X-000-1 https://www.thomann.de/de/rean_rrac3f_x_000_1.htm
Logilink PDU9C02 https://www.lets-sell.de/netzwerk/19-netzwerkschraenke-zubehoer/19-steckdosenleisten-19-zoll/43856/19-steckdosenleiste-9-fach-ein/aus-schalter-19-zoll-f.-rack-serverschrank-netzwerkschrank