1 / 1
Quad(4) ECAS04 Filament Hub for Orbiter v2.5 OSS — zdjęcie 1

Quad(4) ECAS04 Filament Hub for Orbiter v2.5 OSS

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a 4 lane ECAS04 filament hub for the orbiter v2.5 sensor.

Ocena
0 / 5
Polubienia
9
Pobrania
61
Wydruki
0
Wyświetlenia
449
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Recommended to print on its side due to weakness between layers when printed upright. 0.12-0.16mm layer height recommended. Recommended materials are: ABS, ASA, PA, PET (and respective GF/CF variants). PETG might also still work.

When the part is printed go through the following steps:

  1. Fit ECAS04 connectors to the top side.
  2. Dissassemble existing O2 sensor.
  3. Remove / pop out transparent lighting ring.
  4. Create a vertical snip on one side of the ring.
  5. Fit ring over newly printed part.
  6. Push new part into existing O2 housing (quite a bit of force required)
  7. Reassemble with PCB, spring, ball etc. 
  8. All done!

If you have any questions feel free to tag @owendb on the CN3DP discord. 

https://discord.gg/HV75znYsrW

Tagi