1 / 2
strengthened version of HMG7 E3D V6-Revo Six-Dragonfly BMO Collar Skirt V2 — zdjęcie 1
1 / 2

strengthened version of HMG7 E3D V6-Revo Six-Dragonfly BMO Collar Skirt V2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The walls of the mount point/holes for the M3 heat inserts turned out to be too thin for me, so I strengthened them,

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
0
Wyświetlenia
83
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

see as well: https://www.thingiverse.com/thing:7099082 

Print Settings

  • Rafts: No
  • Supports: No
  • Resolution: 0.14 - 0.28
  • Infill: 45%
  • Filament material: ABS (ASA should work as well, PLA might get too warm, it's quite near the heatblock…)

Notes

I printed this in ABS (Geeetech ABS+) like all my HeroMe parts.

For all HeroMe parts, I use

  • outer layer height: 0.14mm
  • inner layer height (inner perimeters and infill). 0.28mm
  • line width 0.6mm
  • 45% infill (not really needed here though)
  • adaptive cubic infill
  • automatic tree support with lean trees, on buildplate only, "only critical" NOT checked

and two postprocessing scripts in OrcaSlicer 2.3.0

The .3MF is for OrcaSlicer 2.3.0, the _generic.3mf is exported from OrcaSlicer als "Generic 3MF", whatever that means.
The STEP file is created by imprting the 3MF into FreeCAD 1.0
and then coverted from the mesh to a solid and exported as "STEP with colors",
the FCStd file is the FreeCAD file from that conversion.

STL is exported from OrcaSlicer. Go for the 3MF if possible.

How I Designed This

Just a few modifications in OrcaSlicer ("add part" / “add negative part”).

Tagi