Ozark Trail 52 qt Cooler Foot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement foot for Ozark Trail 52 qt Cooler.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 276
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
I've had an Ozark Trail 52 qt Cooler for quite a while. It has lost one of its feet, so I modeled one of the remaining feet and printed replacements.
I print this in PETG at .2mm layer height with only painted on supports under the hole on the side facing the bed, 25% infill, 3 perimeters, 5 top layers, 5 bottom layers.
The original feet are made of two materials – one grippy, and one that slides. The PETG should suffice for the one that slides. For grippy, I considered making a change of filament mid-way through the print to TPU to accomplish this, but so far, the sliding feet are a bit better for my uses.