Gridfinity 2*2 Pliers Rack with Deep Cavities
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modification to support pliers with elastic bands at the bottom of the handles.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 367
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Printed the 5*14,5mm version with the cross-beams removed via adding "Negative Parts" in OrcaSlicer, but left the thin reinforcement going up the uprights (photo 1). Left one cross-beam to support the tweezers.
This was done because my printer pliers have their spring at the bottom of the handles, as per the 2nd picture. The pliers are “Pro's Kit PM-396" sub-variants, from AliExpress, and the tweezers are from 2UUL.
However, as this holder sits next to the printer, the latter's vibration would cause the pliers to sway (the handle bottoms are rounded, too), and would make the holder clatter A LOT. On a whim, I slipped some heatshrink tube over the widest part of the uprights, as this is where the metal part of the pliers (especially the rivets) strike, and make noise; this completely deadened the sound.
3MF file attached, which has the floating negative primitives; these show up as massive prisms in the file preview.