BTT EBB36 Sherpa Mini JST Splitter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Splitter for part cooling fans desgined for the Sherpa Mini
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 448
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Due to the BTT EBB36 only coming with one part cooling fan port, a splitter is required. I designed this to be low profile and light weight.
BOM:
1x Angled JST Connector
1x Straight JST Connector
1x Voron Spec Heat Set Insert
2x Cables (For power)
2x Small heat shrink tubing (Optional but reccomended)
A Drop Of Super Glue
Assembly:
After the part is printed, add the heatset insert into the hole, the walls will bend out a bit but this was internional to keep weight down. Than solder the JST connectors ( while they are in place) together keeping track of positive and negitive. Solder your wires down and heat shrink them, Superglue the connectors into the part and replace the bottom (Left or Right, depending on the model you printed, I used Right) with a M3 x 20. Crimp the other ends of your wires and plug them into the BTT EBB36.
I AM NOT RESPONSIBLE FOR ANY ISSUES (ELECTRICAL OR MECHANICAL) THIS MAY CAUSE ON YOUR PRINTER