Speedloader for 30 round 5.56/223 Pmags by Magpul

General:

Speedloader for 30 round Pmag magazine. Split in two to allow printing on smaller print beds. 

Put the magazine into the bottom part. Use the “Pickup tool” to pull rounds directly out of the box. Slide the pickup tool into the loader. Stick the “Ramrod” in the top and push. It's that easy. 

Why I designed this:

One of the least fun parts of shooting is the time spent reloading. Commercial speedloaders for 223/556 lack features or are too expensive.

Printing notes:

Layer height: .15 or finer is ideal, but aesthetic only

Recommended Material: ABS/ASA is probably ideal, but I built and tested with PLA for development.

Supports: Manual(painted) magazine opening of “Bottom” only.

Infill: 20% Triangle

Walls: 3+

Other Modifiers: 

Material Quantity: ≈

I printed from sunlu PLA+ 2.0 on Centauri Carbon at .16 layer height with 25% triangle infill and 3 walls.

Additional materials needed:

Uses (4) M3 X4-5mm long heat-set inserts like these: 

Heat-Set Inserts for Plastic, Brass, M3 x 0.5 mm, 4.3 mm Installed Length | McMaster-Carr

 and (4) M3X6mm long screws like these: 

Button Head Hex Drive Screw, Black-Oxide Alloy Steel, M3 x 0.50 mm Thread, 6 mm Long | McMaster-Carr

_____________________________________________________________________________________________________________

Don’t forget to follow me, post a make, leave a like, or tell me what you don’t like so I can make improvements.

Thanks, and Happy Printing!

Also check out:

https://fabtechmfg.square.site/