Olympia SM2/SM3/SM4 Typewriter Body Mount Bushings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Body mount bushings for the SM2, SM3, and SM4. With built-in alignment on the inner bushing.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 100
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
Body mounts for the Olympia SM2, SM3, and SM4 typewriters. Different than the stock, and plumbing washer methods as the inner bushing has a nub for aligning the body and frame properly as they are slightly offset in order for the carriage and body to be flush at the back of the machine.
Very easy to install, and just like any replacement, only do one at a time. If replacing stock bushings, note that they may have degraded so much that they are very gummy. Be patient and slowly remove as much as you can without causing damage to the body. Try to get as much as you can out because otherwise the new bushings will not sit properly and may cause things to bend.
Two Combinations for Bushings:
1) Standard: Use both files ending in “Standard” for the stock thickness for both inner and outer bushing. This will work on the vast majority of machines.
2) Thick: Use the “Thick” inner and “Thin” outer files. This works if you need an extra bit of clearance between the carriage rails and the body, or the carriage return lever is too close. This isn't common, but made the option for those that might need it.
Both sets of bushings are designed so the screw will bottom out on the frame. So please do not mix standard and thick/thin parts as this will reduce the amount of thread engagement on the screws and possibly lead to issues.
Installation Tips:
- Place typewriter with the back on the table with something soft to prevent damage, Have the bottom of the machine facing you. The spacebar should be at the top facing away from you.
- When putting the inner bushing in, it is okay to push on the inner frame to get the needed amount of room. Given the alignment feature it is thicker than the stock, and other methods.
- Once you have the inner bushing in place, make sure the alignment feature is at the bottom of the cutout and the hole for the screw is above that and aligned with the threads on the frame.
Material/Filament:
- Designed to be printed in TPU. I have had great results with 90A, but you can use softer TPU's if desired. Just know the softer you go, the more movement is allowed in the body and they may settle more loosely over time.
Feel free to print for sale, but I ask that you make pricing reasonable as that is why I went through the effort to model these.
