1 / 4
Radxa Zero 3W/3E Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for Radxa Zero 3W/3E with ventilation holes Prints in 3 pieces + 4 feet
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 150
- Wydruki
- 0
- Wyświetlenia
- 728
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
A smooth and clean enclosure with hex ventilation holes for the Radxa Zero 3W and 3E:
https://radxa.com/products/zeros/zero3w/
https://radxa.com/products/zeros/zero3e/
- Prints in 3 parts (top middle and bottom) and 4 legs that slide into the bottom piece (this decision was made to make the bottom face print smoothly from the bed)
- The GPIO is exposed for easy prototyping work with it.
- It has been carefully designed to be assembled without any screws or threaded inserts, optionally 2 M2.5 3mm screws and threaded inserts can be used to securely mount the board
- The top piece is somewhat loose but I think it's fine so long as you are not violently shaking it
- This case is also compatible with the 3E version's ethernet port however I do not have one to test out its success of fitting.
- 30mmx30mm 5V DC fan cannot be fitted within but it can be placed above the top piece for sufficient ventilation if using Radxa's 5519A heatsink: https://radxa.com/products/accessories/heatsink-5519a/
Support my work: https://ko-fi.com/leafygg