Build Plate Residue Removal Print
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Short print to clear remnant material - Covers the center 30 mm or so of the plate, and is a flat print.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Recommended print settings:
- Material: PLA
- Layer Height: 0.20 (SPEED)
- Infill % : 15+
- Supports: No
- Print Orientation: Default as modeled
I made this part to be a quick print that helps remove stubborn stuck-on material on the build plate. For example, when I print PETG, with supports, I get a lot of material that is very difficult to remove from the plate:
The intent for this print is to print over the stuck-on material in a large flat plate that will help remove the material when the part is lifted.
Here you can see the printer mid-print - the stuck on material is just visible through the first layer:
Final product:
After removal - it didn't take all the material, but it did help loosen what was there. I cleaned the rest up with some mild scraping and pulling
You can see where this print adhered to the stuck material, but couldn't quite pull it loose - it's possible that by being more careful during the removal, I could have gotten this to work better.
Print this to help remove residue from previous prints - for example, when I print a part with PETG and supports, it is very difficult to clean the textured build plate from all the tiny pieces of material.