Everdell Duo double height resource holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
In the original model you needed to print 2 of the resource holders. This model is double height so you only need one.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 193
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Increased the height of the resource bin to double the height (46mm) so you no longer need to print 2 of them. In my play experience one of us would run out of a resource, so it just made sense to have a single pool to pull from. The only resource that didn't fit entirely in a single of the original model was the wood so this remix accommodates that as well.
Printed with PLA at .2mm height, 2 walls, .46mm outer wall, .5mm inner wall, 15% adaptive cubic infill. Used 81g of filament. Printing 2 of the original models would have used over 100g with similar settings.