Virpil Warbrd Stick Axis Scaler

Virpil Warbrd Stick Axis Scaler to adjust the throw of X and Y axis. 

For players that like higher saturations this mod adds the option to insert different physical edge saturation plates that the joystick can be calibrated against. 

Other needed materials
   -16 M3*8 hex head bolts 

   -16 M3x5,7 Threaded Brass inserts and a soldering iron to insert them with

   -4 small washers to attach the base

The print come in 4 pieces.

   -Base Plate

   -Middle Plate 

   -Top plate Left

   -Top plate Right

Assembly 

   -Insert 8 Brass Threaded Inserts into the printed base

  -Insert 8 Brass Threaded Inserts into the inner holes of the middle plate

  -Remove rubber joystick shroud from the Warbrd Base

  -Attach the printed base to the Warbrd base using the original Warbrd hex bolts and 4 small            washers.

                                                               *IMPORTANT* 

                                The holes on the base are intentionally left oversized to allow                                                    adjustment during the stick calibration process. The base may have                                            to be moved around when calibrating to make sure the stick sits center                                         relative to the base. If using light springs the heavy alpha prime sticks tends                                   to lean forward slightly in the resting position. Calibration will likely take                                                                                some trial and error.

    -Attach the middle plate to the base plate with 8 M3*8 Hex bolts                       

   -(Optional) Cut a small piece of fabric to act as a dust barrier. Lay between the middle and          top plate

   -Attach Left and Right top plate of the desired size with M3*8 Hex bolts