Malolo's Silica Gel / Desiccant Containers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Wstępna wycena dla PETG
3,30 € – 4,04 € netto (bez VAT)
Dla pliku: 50x50 Full Core 0.2mm PETG from Slic3rPE / 50x50_fullcore_v2_02mm_pet_mk3s.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 3,67 € netto (środek widełek).
- Masa podana przez autora
- 28 g
- Czas druku podany przez autora
- 4,62 godz.
- Materiał u źródła
- PET
- Materiał wyceny
- PETG
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
I designed this silica gel container mostly for two reasons: I looked at several different silica gel containers and…
- Ocena
- 4,939 / 5
- Polubienia
- 2049
- Pobrania
- 11 389
- Wydruki
- 332
- Wyświetlenia
- 36 162
- Oceny
- 311
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed this silica gel container mostly for two reasons:
- I looked at several different silica gel containers and even printed a few but always found something I was not entirely happy with (I most likely didn't look at every single option there is though).
- Designing stuff is just so much fun (something I actually didn't expect before I purchased my 3D printer)
These are the things I tried to achieve:
- The silica gel I bought consists of rather small pieces (especially when the pieces are broken). Therefore the gaps in the walls should be pretty narrow but still let a lot of air in. Slots seem to fit this requirement better than holes. To let even more air in I added a hole at the bottom that contains air slots as well.
- Opening it should be be quick and easy but it should be more or less impossible to be opened by accident. Something with a screwable lid seems the best choice for this.
- It should fit inside a filament spool.
- It should be easy to print and and don't require supports.
- It should be reasonably sturdy but don't waste too much filament.
There are three different variants (best seen in the second picture):
- NoCore - Regular container without hole in center
- HalfCore - Container with hole in center half way through
- FullCore - Container with hole in center all the way through (including lid)
Each variant comes in four different sizes. All have a diameter of 50mm. There heights (including the lid) are:
- 30mm
- 50mm
- 75mm
- 100mm
The lid is the same for all sizes. The FullCore variants have their own lid with a hole in the center.
To aid filling the FullCore variants with silica gel there also is a center plug and a screw on funnel.